Filter
Top Products
Back to Removing and Replacing Parts
Heat Sink and Processor Fan
Dell™Latitude™E6410/E6410ATGServiceManual
Removing the Heat Sink and Processor Fan
1. Follow the procedures in Before Working Inside Your Computer.
2. Remove the ATG Port Cover (applicable on E6410 ATG computer only).
3. Remove the battery
4. Remove the access panel
5. Remove the coin-cell battery
6. Disconnect the fan cable from the system board.
7. Loosen the captive screws on the heat sink.
8. Lift the edge of the heat sink that is closest to the center of the computer, and then slide the heat sink out of the computer.
Replacing the Heat Sink and Processor Fan
To replace the heat sink and processor fan, perform the above steps in reverse order.
Back to Removing and Replacing Parts
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
NOTE: You may need to install Adobe®Flash®Player from Adobe.com in order to view the illustrations below.