Dell G1 Laptop User Manual


 
Installing System Board Options 6-7
 ,I\RXDUHUHPRYLQ JWKHFDUGSHUPDQ HQWO\LQVWDOODPHW DOILOOHUEUDFNHW
RYHUWKHHPSW\FDUG VORWRSHQLQJ
NOTE: Installing filler brackets over empty card-slot openings is necessary to
maintain Federal Communications Commission (FCC) certification of the system.
The brackets also keep dust and dirt out of your computer.
 5HSODFHWKHH[SDQVLRQFDUGFDJHLQWKHFKDVVLVDVLQVWUXFWHGLQ
´5HSODFLQJWKH([SDQVLRQ&DUG&DJHµLQ&KDSWHU
 5HSODFHWKHFRPSXWHUFRYHUUHFRQQHFW\RXUFRPSXWHUDQGSHULSKHUDOV
WRWKHLUSRZHUVRXUFHVDQGWXUQWKHPRQ
NOTE: After you remove and replace the cover, the chassis intrusion detector will
cause the following message to be displayed at the next system start-up:
$/(57&RYHUZDVSUHYLRXVO\UHPRYHG
 7RUHVHWWKHFKDVVLVLQWUXVLRQGHWHFWRUHQWHUWKH6\VWHP6HWXSSURJUDP
DQGUHVHW&KDVVLV,QWUXVLRQWR1RW'HWHFWHG
See Chapter 2, “Using the System Setup Program,” for instructions.
NOTE: If a setup password has been assigned by someone else, contact your
network administrator for information on resetting the chassis intrusion detector.
$GGLQJ0HPRU\
Memory can be increased to a maximum of 256 megabytes (MB) by installing combi-
nations of 32-, 64-, or 128-MB dual in-line memory modules (DIMMs) in the two
DIMM sockets on the system board. Figure 6-6 shows the DIMMs and DIMM sock-
ets. Your system can support nonparity synchronous dynamic random-access
memory (SDRAM) DIMMs. DIMM speed (66 MHz or 100 MHz) should match the
external bus speed of the microprocessor.
&$87,21'RQRWDWWHPSWWRLQVWDOO0+]',00 VRQDV\VWHPWKDWKDVDQ
H[WHUQDOEXVVSHHGRI0+]$WWHPSWLQJWRLQVWDOORQO\0+]',00V
ZLOOSUHYHQWWKHV\VWHPIURPERRWLQJRUVWDUWLQJXS
Using a mixture of 66-MHz and 100-MHz DIMMs on a system that has an external
bus speed of 100 MHzgenerates the following error message:
$OHUW:URQJVSHHGPHPRU\PRGXOHGHWHFWHGLQ',00VRFNHWQ
3OHDVHUHSODFHZLWKD[[[0+]PHPRU\PRGXOH