Filter
Top Products
• The controller detects an Error-Correcting Code (ECC) error while performing its cache
checking routine during initialization.
• The controller discards the cache rather than sending it to the disk subsystem because
the data integrity cannot be guaranteed.
Corrective
Action:
To resolve this issue, allow the battery to charge fully. If the problem persists, the battery or
controller memory may be faulty; contact Dell Technical Support.
Missing Disks In Virtual Disk Error Message
Error Message:
The following virtual disks have missing disks: (x). If you
proceed (or load the configuration utility), these virtual
disks will be marked OFFLINE and will be inaccessible. Please
check your cables and ensure all disks are present. Press any
key to continue, or 'C' to load the configuration utility.
Probable Cause: The message indicates that some configured disks were removed. If the disks were not
removed, they are no longer accessible. The SAS cables for your system might be improperly
connected.
Corrective
Action:
Check the cable connections and fix any issues. Restart the system. If there are no cable
problems, press any key or <C>to continue.
Previous Configuration Of Disks Removed Error Message
Error Message:
All of the disks from your previous configuration are gone. If
this is an unexpected message, then please power off your
system and check your cables to ensure all disks are present.
Press any key to continue, or press <C> to load the
configuration utility.
Probable Cause: The message indicates that some configured disks were removed. If the disks were not
removed, they are no longer accessible. The SAS cables for your system might be improperly
connected.
Corrective
Action:
Check the cable connections and fix any issues before restarting the system. If there are no
cable problems, press any key or <C> to continue.
Missing Virtual Disks Error Message
Error Message:
The following virtual disks are missing: (x). If you proceed
(or load the configuration utility), these virtual disks will
be removed from your configuration. If you wish to use them at
a later time, they will have to be imported. If you believe
these virtual disks should be present, please power off your
system and check your cables to ensure all disks are present.
Press any key to continue, or 'C' to load the configuration
utility.
Probable Cause: The message indicates that some configured disks were removed. If the disks were not
removed, they are no longer accessible. The SAS cables for your system might be improperly
connected.
72