Filter
Top Products
Installing the GPS Holder
1. Place the GPS holder into its place on the computer.
2. Tighten the screw that secure the holder to the computer.
3. Connect the antenna cable.
4. Align the cable to the computer.
5. Install:
a. Bottom Cover
b. Optical Drive
c. Hard Drive
d. Battery
6. Follow the procedures in After Working Inside Your computer
Removing the Heatsink
1. Follow the procedures in Before Working Inside Your Computer
2. Remove:
a. Battery
b. Hard Drive
c. Optical Drive
d. Bottom Cover
e. Docking Board
f. GPU Board
g. SIM Module
3. Loosen the screws that secure the heatsink to the system board in the sequence shown [1,2,3,4].
NOTE: The screws are retained by the heatsink and should not be fully removed.
20