Filter
Top Products
Installing the System Fan
1. Place the system fan into its place on the computer.
2. Tighten the screw that secures the system fan to the computer
3. Connect the system fan cable to the computer.
4. Route the system fan cable.
5. Install:
a. Bottom Cover
b. Optical Drive
c. Hard Drive
d. Battery
6. Follow the procedures in After Working Inside Your computer
Removing the RF Holder
1. Follow the procedures in Before Working Inside Your Computer
2. Remove:
a. Battery
b. Hard Drive
c. Optical Drive
d. Bottom Cover
e. GPS Holder
f. WLAN Card
g. Docking Board
3. Perform the following steps as shown in the illustration:
a. Unthread the antenna cables [1].
b. Disconnect the antenna cables [2].
c. Remove the screw that secures the RF Holder to the computer [3].
d. Lift and remove the RF Holder from the computer [4].
22