Filter
Top Products
Installing the I/O Board
1. Place the I/O board on the computer.
2. Tighten the scews that secure the I/O board to the computer.
3. Connect display assembly cable to the computer.
4. Connect the I/O cable to the computer.
5. Tighten the screw that secures the I/O board.
6. Slide the I/O board into its place on the computer.
7. Close the I/O bay press latch door.
8. Install:
a. Bottom Cover
b. Optical Drive
c. Hard Drive
d. Battery
9. Follow the procedures in After Working Inside Your computer
Removing the Storage Connector
1. Follow the procedures in Before Working Inside Your Computer
2. Remove:
a. Battery
b. Hard Drive
c. Optical Drive
d. Bottom Cover
3. Perform the following steps as shown in the illustration:
a. Lift the locking tab [1].
b. Disconnect the storage connector cable [2].
c. Remove the screw that secures the storage connector [3].
d. Lift the storage connector from the computer [4].
27