Filter
Top Products
4. Affix the adhesive tape.
5. Connect the display assembly cable
6. Affix the tape.
7. Install:
a. Bottom Cover
b. Hard Drive
c. Optical Drive
d. Battery
8. Follow the procedures in After Working Inside Your computer
Removing the Battery Connector
1. Follow the procedures in Before Working Inside Your Computer
2. Remove:
a. Battery
b. Hard Drive
c. Optical Drive
d. Bottom Cover
e. I/O Board
3. Perform the following steps as shown in the illustration:
a. Disconnect the battery connector cable [1].
b. Remove the screws that secure the battery connector [2].
c. Lift the battery connector [3].
Installing the Battery Connector
1. Place the battery connector on the system board..
2. Tighten the screws that secure the battery connector to the computer.
3. Connect the battery connector cable.
4. Install:
a. I/O Board
b. Bottom Cover
c. Optical Drive
d. Hard Drive
31