Filter
Top Products
OSPFv3 Commands 1213
User Guidelines
Some of the information below displays only if you enable OSPF and
configure certain features. The following fields may be displayed:
Field Description
Router ID A 32-bit integer in dotted decimal format identifying the router
about which information is displayed. This is a configured value.
OSPF Admin
Mode
Shows whether OSPF is administratively enabled or disabled.
External LSDB
Limit
Shows the maximum number of non-default external LSAs
entries that can be stored in the link-state database.
Exit Overflow
Interval
Shows the number of seconds that, after entering
OverflowState, as defined by RFC 1765, a router will attempt to
leave OverflowState.
AutoCost Ref BW The configured autocost reference bandwidth. This value is used
to determine the OSPF metric on its interfaces. The reference
bandwidth is divided by the interface speed to compute the
metric.
Default Passive
Setting
When enabled, OSPF interfaces are passive by default.
Maximum Paths Shows the maximum number of paths that OSPF can report for
a given destination.
Default Metric Default metric for redistributed routes.
Default Route
Advertise
When enabled, OSPF originates a type 5 LSA advertising a
default route.
Always When this option is configured, OSPF only originates a default
route when the router has learned a default route from another
source.
Metric Shows the metric for the advertised default routes. If the metric
is not configured, this field is not configured.
Metric Type Shows whether the metric for the default route is advertised as
External Type 1 or External Type 2.
Number of Active
Areas
The number of OSPF areas to which the router is attached on
interfaces that are up.
2CSPC4.XCT-SWUM2XX1.book Page 1213 Monday, October 3, 2011 11:05 AM