Filter
Top Products
1542 SNMP Commands
Example
The following example sets the device location as "New_York".
console(config)# snmp-server location New_York
snmp-server user
Use the snmp-server user command in Global Configuration mode to
configure a new SNMP Version 3 user. To delete a user, use the no form of this
command.
Syntax
snmp-server user
username groupname
[remote
engineid-string
] [ { auth-
md5
password
| auth-sha
password
| auth-md5-key
md5-key
| auth-sha-key
sha-key
} [priv-des
password
| priv-des-key
des-key
] ]
no snmp-server user
username
•
username
— Specifies the name of the user on the host that connects to
the agent. (Range: 1-30 characters.)
•
groupname
— Specifies the name of the group to which the user belongs.
(Range: 1-30 characters.)
•
engineid-string
— Specifies the engine ID of the remote SNMP entity to
which the user belongs. The engine ID is a concatenated hexadecimal
string. Each byte in the hexadecimal character string is two hexadecimal
digits. The remote engine id designates the remote management station,
and should be defined to enable the device to receive acknowledgements
to "informs." (Range: 5-32 characters.)
•
auth-md5
— The HMAC-MD5-96 authentication level.
•
auth-sha
— The HMAC-SHA-96 authentication level.
•
password
— A password. (Range: 1 to 32 characters.)
• auth-
md5-key
— The HMAC-MD5-96 authentication level. Enter a
pregenerated MD5 key.
• auth-
sha-key
— The HMAC-SHA-96 authentication level. Enter a
pregenerated SHA key.
•
md5-key
— Character string
—
length 32 hex characters.
•
sha-key
— Character string
—
length 48 characters.
2CSPC4.XCT-SWUM2XX1.book Page 1542 Monday, October 3, 2011 11:05 AM