Filter
Top Products
LLDP Commands 583
Parameter Ranges
Not applicable
Command Mode
Interface (Ethernet) Configuration
Default Value
By default, notifications are disabled on all supported interfaces.
Usage Guidelines
No specific guidelines.
Example
console(config)#lldp med confignotification
lldp med faststartrepeatcount
This command is used to set the value of the fast start repeat count.
Syntax Description
lldp med faststartrepeatcount
count
no lldp med faststartrepeatcount
•
count
— Number of LLDPPDUs that are transmitted when the protocol is
enabled. (Range 1–10)
Command Mode
Global Configuration
Default Value
3
Usage Guidelines
No specific guidelines.
2CSPC4.XCT-SWUM2XX1.book Page 583 Monday, October 3, 2011 11:05 AM