Filter
Top Products
8-18 Installation and Troubleshooting Guide
4. Locate the battery and remove it. The battery is mounted in a socket labeled
"BATTERY" (see Figure 8-1).
"%,""0-"
!","01%
"0","%"
! ",-!!&
!"" %""%
!"
Pry the battery out of its socket with your fingers or with a blunt, nonconductive
object, such as a plastic screwdriver (see Figure 8-15).
&
5. Install the new battery. Orient the battery with the side labeled "+" facing up.
Then insert the battery into the socket, and snap it into place.
6. Rotate the power supply back into position, making sure that the securing tab
snaps into place.
7. Replace the computer cover, and reconnect your computer and peripherals to
their power sources and turn them on.
NOTE: After you remove and replace the cover, the chassis intrusion detector will
cause the following message to be displayed at the next system start-up:
ALERT! Cover was previously removed.
8. Enter the System Setup program, and confirm that the battery is operating prop-
erly. See your
User's Guide
for information on running the System Setup
program. Enter the correct time and date through the System Setup program's
Time and Date options. Also, restore the correct settings for the system configu-
ration information using the copy made in step 1.
battery
BATTERY socket