Filter
Top Products
Command Groups 123
IPv6 Routing
show ipv6 pimsm interface Displays interface config parameters. PE
show ipv6 pimsm neighbor Displays IPv6 PIM neighbors learned on the
routing interfaces.
PE
show ipv6 pimsm rphash Displays which rendezvous point (RP) is being
selected for a specified group.
PE
show ipv6 pimsm rp
mapping
Displays all group-to-RP mappings of which the
router is aware (either configured or learned
from the bootstrap router (BSR).
PE
a. For the meaning of each Mode abbreviation, see Mode Types on page 77.
Command Description Mode
a
clear ipv6 neighbors Clears all entries in the IPv6 neighbor table
or an entry on a specific interface.
PE
clear ipv6 statistics Clears IPv6 statistics for all interfaces or for a
specific interface, including loopback and
tunnel interfaces.
PE
ipv6 address Configures an IPv6 address on an interface
(including tunnel and loopback interfaces).
IC
ipv6 enable Enables IPv6 routing on an interface
(including tunnel and loopback interfaces)
that has not been configured with an explicit
IPv6 address.
IC
ipv6 hop-limit Configures the hop limit used in IPv6 PDUs
originated by the router.
GC
ipv6 host Defines static host name-to- ipv6 address
mapping in the host cache.
GC
ipv6 mld last-member-
query-count
Sets the number of listener-specific queries
sent before the router assumes that there are
no local members on the interface.
IC
(VLAN)
Command Description Mode
a
2CSPC4.XModular-SWUM200.book Page 123 Thursday, March 10, 2011 11:18 AM