Filter
Top Products
VLAN Commands 751
vlan protocol group
Use the vlan protocol group command in Global Configuration mode to add
protocol-based groups to the system. When a protocol group is created, it is
assigned a unique group ID number. The group ID is used to identify the
group in subsequent commands. Use the no form of the command to remove
the specified VLAN protocol group name from the system.
In previous implementations, when multiple VLAN protocol groups when
created, and then one of the groups was deleted and the configuration was
saved, this command resulted an in incorrect application of the groupids
upon reload So, the existing command vlan protocol group
groupname
is
updated to vlan protocol group
groupid
so that groupid is used for both
configuration and script generation.
NOTE: If an attempt is made to migrate to the latest implementation with any of the
groupnames deleted prior to saving configuration on the pre 3.0.0.x code
(applicable only for platforms PC62xx, PCM622x, PCM8024), the problem on the
latest code will remain.
Syntax
vlan protocol group
groupid
no vlan protocol group
groupid
•
groupid
— The protocol-based VLAN group ID, to create a protocol-based
VLAN group. To see the created protocol groups, use the
show port
protocol al
l command.
Default Configuration
This command has no default configuration.
Command Mode
Global Configuration mode
User Guidelines
This command has no user guidelines.
Example
console(config)# vlan protocol group 1
2CSPC4.XModular-SWUM200.book Page 751 Thursday, March 10, 2011 11:18 AM