Filter
Top Products
VLAN Commands 727
User Guidelines
This command has no user guidelines.
Example
The following example displays how to add a physical port interface to the
group ID of "2."
console(config-if-1/0/1)#protocol vlan group 2
protocol vlan group all
Use the protocol vlan group all command in Global Configuration mode to
add all physical interfaces to the protocol-based group identified by
groupid
.
A group may have more than one interface associated with it. Each interface
and protocol combination can be associated with one group only. If adding an
interface to a group causes any conflicts with protocols currently associated
with the group, this command fails and the interface(s) are not added to the
group. Ensure that the referenced VLAN is created prior to the creation of the
protocol-based group except when GVRP is expected to create the VLAN.
To remove all interfaces from this protocol-based group that is identified by
this
groupid
, use
the no form of the command
Syntax
protocol vlan group all
groupid
no protocol vlan group all
groupid
•
groupid
— The protocol-based VLAN group ID, which is automatically
generated when you create a protocol-based VLAN group with the
vlan
protocol group
command. To see the group ID associated with the name
of a protocol group, use the
show port protocol all
command.
Default Configuration
This command has no default configuration.
Command Mode
Global Configuration mode
2CSPC4.XModular-SWUM200.book Page 727 Thursday, March 10, 2011 11:18 AM