Filter
Top Products
128 Command Groups
ip pim spt-threshold Sets the multicast traffic threshold rate for the
last-hop router to switch to the shortest path on
the router.
GC
show bridge multicast
address-table count
Displays statistical information about the
entries in the multicast address table.
PE
show ip mcast Displays the system-wide multicast
information.
PE
show ip mcast boundary Displays the system-wide multicast
information.
PE
show ip mcast interface Displays the multicast information for the
specified interface.
PE
show ip mcast mroute Displays a summary or all the details of the
multicast table.
PE
show ip mcast mroute
group
Displays the multicast configuration settings of
entries in the multicast mroute table.
PE
show ip mcast mroute
source
Displays the multicast configuration settings of
entries in the multicast mroute table.
PE
show ip mcast mroute
static
Displays all the static routes configured in the
static mcast table.
PE
show ip pim bsr-router Displays the bootstrap router (BSR)
information.
PE
show ip pim interface Displays PIM interface status parameters. If no
interface is specified, the command displays the
status parameters of all PIM-enabled interfaces.
UE or
PE
show ip pim neighbor Displays PIM neighbors discovered by PIMv2
Hello messages. If no interface is specified, the
command displays the neighbors discovered on
all PIM-enabled interfaces.
UE or
PE
show ip pimrphash Displays the rendezvous point (RP) selected for
the specified group address.
UE or
PE
show ip pim rp mapping Displays the mappings for the PIM group to the
active rendezvous points (RPs).
UE or
PE
a. For the meaning of each Mode abbreviation, see Mode Types on page 77.
Command Description Mode
a
2CSPC4.XModular-SWUM200.book Page 128 Thursday, March 10, 2011 11:18 AM