Filter
Top Products
38 Using the System Setup Program
USB Flash Drive
Emulation Type
(
Auto
default)
Determines the emulation type for a USB flash drive.
Floppy allows the USB flash drive to act as a removable
floppy disk, and it will be assigned a drive letter of A: or B:.
Hard disk allows the USB flash drive to act as a hard drive.
Auto automatically chooses an emulation type.
Boot Sequence Retry
(
Disabled
default)
Enables or disables retrying the boot sequence that was
specified in the Boot Sequence option.
Integrated Devices See "Integrated Devices Screen" on page 41.
PCI IRQ Assignment Displays a screen to change the IRQ assigned to each of the
integrated devices on the PCI bus, and any installed
expansion cards that require an IRQ.
Console Redirection See "Console Redirection Screen" on page 42.
System Security Displays a screen to configure the system password and
setup password features. See "Using the System Password"
on page 45 and "Using the Setup Password" on page 48 for
more information.
Keyboard NumLock
(On default)
Determines whether your system starts up with the
NumLock mode activated on 101– or 102–key keyboards
(does not apply to 84-key keyboards).
Report Keyboard Errors
(Report default)
Enables or disables reporting of keyboard errors during the
POST. Enable this option for host systems that have
keyboards attached. Select Do Not Report to suppress all
error messages relating to the keyboard or keyboard
controller during POST. This setting does not affect the
operation of the keyboard itself if a keyboard is attached to
the system.
Table 2-2. System Setup Program Options (continued)
Option Description
book.book Page 38 Thursday, August 30, 2007 3:30 PM