Filter
Top Products
Installing System Components 95
13
Connect the control-panel interface cable to the FP_CONN1 connector
on the system board. See Figure 6-2 for the location of the FP_CONN1
connector.
14
If applicable, connect the optical drive interface cable to the SATA_2
connector on the system card. See Figure 6-2 for the location of the
SATA_2 connector.
15
Install the cooling shroud. See "Installing the Cooling Shroud" on page 57.
16
Close the system. See "Closing the System" on page 55.
book.book Page 95 Thursday, August 30, 2007 3:30 PM