Filter
Top Products
98 Installing System Components
5
Install the expansion card:
a
Holding the card by its edges, position the card so that the card-edge
connector aligns with the expansion-card connector on the expansion-
card riser.
b
Insert the card-edge connector firmly into the expansion-card
connector until the card is fully seated.
c
Close the expansion-card latch. See Figure 3-11.
Figure 3-11. Installing or Removing an Expansion Card
6
Connect any cables to the expansion card.
7
Close the system. See "Closing the System" on page 83.
8
Reconnect the system to its electrical outlet and turn the system on,
including any attached peripherals.
1 expansion-card latch 2 expansion card
3 expansion-card riser
2
1
3
book.book Page 98 Tuesday, March 31, 2009 5:26 PM