Filter
Top Products
10
20. Attach sensor cover by snapping clips over screen frame.
Secure to frame by screwing down into the upper channel of
the screen frame with supplied #8 x 3/4” screw (Figure 12).
21. In between the projector mount and the IR sensor
cover, cable clips will be mounted to the wall for cable
management. Attach clips to the wall using:
Wood studs: (4) supplied #8 x 1” screws.
Concrete wall or no studs: (4) supplied #8-10
wall anchors and (4) supplied #8 x 1” screws.
When secure, route cables and cords behind the two cable
clips. Attach cable cover to the cable clips (Figure 13).
NOTE: Two cable clips are shipped with the screen/
whiteboard. For some installations, only one cable clip may
be needed.
22. Install projector mount covers and projector (Figure 14).
Refer to the S520 Dual Stud Wall Mount (MSP-DCCUST1)
manual.
Figure 14
Figure 12
Figure 13
DC Power
Cable for
Sensor
Installation (continued)