Filter
Top Products
6
NOTE: The (3) 1/4” x 1-1/2” bolts and (3) washers required in
Steps 6-8 are NOT INCLUDED with the screen/whiteboard
packaging.
6. Install (1) 1/4” x 1-1/2” bolt and (1) washer through middle
of bracket into previously drilled hole, leaving 1/2” of the
bolt extending from wall. Use carpenter’s level to make
sure bracket is properly level (Figure 2).
7. Position level on top of wall bracket. Move bracket until
level. Drill (2) holes for the other bolts in wall studs.
8. Install the other (2) 1/4” x 1-1/2” bolts and (2) 1/4” washers
in the previously drilled holes. Tighten all bolts against wall
bracket.
9. Measure down 52-1/4” on center and mark spot. Move
right and left of screen until wall studs are found and mark
(Figure 3).
Middle Fastener
Previously
Drilled Hole
Center of
Screen
Center of Screen
Figure 2
Figure 3
52-1/4 in.
Installation (continued)