Filter
Top Products
1-6 Dell Dimension XPS R
xxx
Systems Setup Guide
10. In the
Windows NT Setup
window, Click
Next>
.
If your system has a network card, it is automatically detected and the required
files are copied to your hard-disk drive. Go to step 11.
If your system does not have a network card, go to step 14.
11. When prompted for information about network connections, click the
Do Not
Connect This Computer to a Network at This Time
radio button.
Setup configures your files to run Windows NT, and the appropriate files are then
copied to your hard-disk drive.
NOTE: You can add or update network hardware or software after completing this
setup procedure by double-clicking the
Network
icon in the
Control Panel
and
providing the necessary information.
12. Click
Next>
.
The
Computer Name
window appears and prompts you to enter the name of
your computer.
13. Type the unique name used to identify your computer on a network (up to
15 characters) and click
Next>
.
14. If you have a modem installed, the
Install New Modem
window appears. Con-
tinue with step 15.
If you do not have a modem installed, click
Cancel
and proceed to step 20.
15. Click
Next>
to let Windows NT detect any installed modem.
Dell recommends that you let Windows NT detect your modem. However, you
can click the
Don’t Detect My Modem; I Will Select From a List
radio button,
and then manually select a modem.
16. Click
Next>
to continue the modem setup, or click
Change...
to select a different
modem.
Windows NT then installs the modem drivers and prompts you for information
about your current location.
17. Select the appropriate country from the drop-down list box. Provide your area
(city) code and any telephone number required to access an outside line. Specify
whether you are using tone or pulse dialing. Then click
Next>
.
If you do not provide an area (city) code, the
Dialing Properties
dialog box
appears and prompts you to enter a code.
18. When a message tells you that the modem setup was successful, click
Finish
.
19. Verify the settings in the
Modem Properties
window; then click
Close
.