Filter
Top Products
PD-01 PROFIBUS-DP Module
DELTA ELECTRONICS, INC. ALL RIGHTS RESERVED
7
Chapter 3 Installation
IMPORTANT NOTE:
Prior to the installation or remove the PD-01 from network, make sure the power of VFD
series Drives is switched off (not-energized).
Installing the PD-01
Improper installation of the PD-01 will cost its life usage. Please follow the instructions to
install your PD-01 carefully.
DIN Rail Installation
PD-01 can be secured by mounting to DIN rail. There is a small retaining clip locates at
the bottom of PD-01, place the PD-01 onto the DIN rail and gently push up on the clip to
ensure the PD-01 is mounted to the DIN rail.
Direct Mounting
Please use the specified M4 screws to install the PD-01. Also please ensure to tighten
them properly.
Screw
Mounting
Hole
DIN RAIL
CLIP