Filter
Top Products
DeviceNet Slave Communication Module DVPDT02-H2
DVP-PLC Application Manual
10
DeviceNet
DVP28SV
DVPDNET-SL
DVPDNET DVP28SV
RUN
STOP
Master
DeviceNet
network configuration tool
STOP
RUN
01
IN
OUT
POW ER
RUN
ERRO R
BAT.LOW
DVP-20EH
2. Configuring DVPDNET-SL network scanner and DVPDT02-H2:
Module Node address Baud rate
DVPDNET-SL 1 500kbps
DVPDT02-H2 2 500kbps
3. Please check and make sure DVP-EH2 PLC MPU and DVPDT02-H2 module both operate normally.
Check also the wiring of the entire network and make sure the power supply on DeviceNet network is
normal.
¡ Configuring the network by DeviceNet network configuration tool
Configuration DVPDT02-H2
1. Open DeviceNetBuilder.
2. Select “Setup“ => “Communication Setting” => “System Channel”, and you will see the “Serial Port Setting”
dialog box.