2
Hardware Installation
19
2. SECC processor:
Position the SECC processor above Slot 1 with the notch in
the processor aligned with the key on the slot. Push the
processor down firmly, with even pressure on both sides of the
top, until it is completely seated. Push the latches located on the
top sides of the processor outward until they click into place in
the URM.
SECC2 or SEPP processor:
Position the SECC2 or SEPP processor above Slot 1 with the
notch in the processor aligned with the key on the slot. Push
the processor down firmly, with even pressure on both sides of
the top, until it is completely seated. The sides of the processors
heatsink will click and lock through the slit of the URMs tab.
Make sure the slide is in the LOCK position.
Slit of the
URMs tab
Slide
2.3.2 Removing the Processor
SECC processor:
Push the latches on the top sides of the processor toward the
center until they click into place. Lift one end of the processor until it
is freed from Slot 1. Lift the other end of the processor until it is
freed from Slot 1. Lift the entire processor until it is free from the
URM.