Filter
Top Products
2
Hardware Installation
35
2.7.17 Chassis Open Connector
The chassis open function, when enabled, will alert you that the
system chassis is open. To use this function, please follow the steps
below.
1. Connect the chassis sensor cable that is attached on your
system chassis to location J22 on the system board.
2. Install the Hardware Doctor utility contained in the provided
CD. By default, the chassis open function is disabled. When
enabled, a warning message will appear when the chassis is open.
The utility may also be configured so that a beeping alarm will
sound when the chassis is open. Refer to Hardware Doctor
Utility in chapter 4 for instructions on installing the utility.
Pin
1
2
3
4
Function
Ground
Chassis signal
N. C.
+5V