Filter
Top Products
2
Hardware Installation
33
2.7.15 Wake-On-LAN Connector
The Wake-On-LAN connector is used to connect to a LAN card
that has the same connector. This function will allow the network to
remotely power-on a Soft Power Down (Soft-Off) PC. However, if
your system is in the Suspend mode, you can power-on the system
only through an IRQ or DMA interrupt.
To use the Wake-On-LAN function, you must enable the Resume on
LAN field in the Power Management Setup of the BIOS. Your LAN
card package should include a cable. Connect one end of the cable
to the wakeup header on the card and the other end to location
J21 on the system board. The network will detect Magic Packet and
assert a wakeup signal to power-up the system. Refer to the add-in
cards manual for details. Note: Your LAN card must support the
remote wake up function.
Important:
The 5VSB power source of your power supply must support a
minimum of 1.5A.
Pin
1
2
3
Function
WOL
Ground
+5VSB