Filter
Top Products
57
3
Award BIOS Setup Utility
Soft-Off by PWR-BTTN
This category allows you to select the method of powering off your
system.
Hold 4 Sec. Regardless of whether the Power Management field
is enabled or disabled, if the power button is
pushed and released in less than 4 sec, the system
enters the Suspend mode. The purpose of this
function is to prevent the system from powering off
in case you accidentally hit or pushed the power
button. Push and release again in less than 4 sec to
restore. Pushing the power button for more than 4
seconds will power off the system.
Instant-Off Pressing and then releasing the power button at
once will immediately power off your system.
Resume on PCI Event
This field should be set to Enabled only if your PCI card such as
LAN card or modem card uses the PCI PME (Power Management
Event) signal to remotely wake up the PC. Refer to the cards
documentation for more information.
Resume On Ring
Set this field to Enabled to use the modem ring-on function. This will
allow your system to power-on to respond to calls coming through
an external or internal modem. Refer to Wake-On-Ring Connector
in chapter 2 for more information.
Resume On LAN
If you are using a LAN card that supports the remote wake up
function, set this field to Enabled. The will allow the network to
remotely wake up a Soft Power Down (Soft-Off) PC. However, if
your system is in the Suspend mode, you can wake up the system
only through an IRQ or DMA interrupt. Refer to Wake-On-LAN
Connector in chapter 2 for more information.