Filter
Top Products
3-4 Configuring Ports for RealPort: Command Line
Configuring Ports for RealPort: Command Line
This section describes how to configure RealPort ports from the command line.
Procedure
Use this procedure to use the command line to configure PortServer TS 8/16 for RealPort.
This procedure assumes that you have signed on as root and have or will
• Install RealPort software on each RealPort host. See the appropriate RealPort documentation for
more information.
• Properly cabled PortServer TS 8/16 ports and devices.
• Set up the devices connected to PortServer TS 8/16 ports
1. Configure the RealPort TCP port by entering the following command:
set tcp realport=771
2. Configure PortServer TS 8/16 ports by entering the following command:
set ports range=range dev=rp
where range is the range of ports to which this command applies
Example:
set ports range=2 dev=rp
Example
In this example, all ports are configured for RealPort.
set tcp realport=771
set ports range=* dev=rp