Filter
Top Products
49
Frequently Asked Questions (continued)
Remarks:
- Actual Clearance is > 32.8 feet (10m.)
- Distances over 25 Miles (40km) are very difficult to align and install.
- This range is the maximum range, the real range depends on
environmental factors.
- This chart is based on 2dB cable and connector loss.
Q3: How can you tell if a connection between two DWL-1750s (Central/
Remote) is established or not?
A:
Note: This function is only supported in Remote Router/Bridge mode.
Q4: How do you backup the MAC Filters or Firewall rules in DWL-1750?
A:
Q5: How can I reset the DWL-1750 to the factory default value?
A:
From the WEB GUI – click the Default button in Tools > System
From the RS-232 console – In the console window, press the D button
on the keyboard and choose the Y to reset the DWL-1750 to its factory
default setting.
Q6: Does the DWL-1750 support the function to change to output power
manually?
A: The function is not supported in the current version.
Go to the Tools>System window in the Configuration Utility. Use the
backup function on that page.
You can check the Wireless Link Information in the Status >
Wireless screen in the Configuration Utility. You will find the Link
Quality, Signal Strength, Current radio channel and Current Tx
Rate to show you if your connection has been established.