Filter
Top Products
80
5. Troubleshooting
5. Troubleshooting
Problem Likely Cause Things to Check
Reference
Page
Number
No image
The projector is not turned
on.
Is the projector's lamp on? *17
The projector's input source
isn't switched to MIU.
Is the projector switched to
MIU?
*18
Wireless / Wired
Live Mode
The projector
that you want
to connect to
is nowhere
to be found
on the list
of available
projectors
The PC and/or projector's
network settings are not
configured correctly.
Check both the PC
and projector's network
settings. If you change the
projector's settings, turn off
the projector's AC power
and then turn it on again.
If you simply put the
projector in STANDBY
power mode and then
turn it on again, the new
settings might not take
effect.
8, 10, 16
Weak radio signal
• Bring the PC and
projector closer together
• Radio waves won't go
through concrete and
metal (steel doors, etc.)
–
Can't
communicate
The Projector isn't in Live
Mode
Check the mode on MIU
Menu to make sure that it is
in the correct mode.
50
The projected
image is
rather slow
compared to
that of the PC
The projector isn't capable
of relaying dynamic images
such as PowerPoint®
animation at full speed.
Try increasing the Capture
Performance priority level.
It may improve the speed a
little.
48
The compression rate
being used for transferring
the images is too low.
Try setting the image
compression to "Low."
The resolution will drop
in quality, but it may help
improve the speed.
48
(continued on next page)