Filter
Top Products
6
To insert the batteries
1. Slide the battery compartment cover
away from the label maker. See Figure 2.
2. Insert the batteries following the
polarity markings (+ and –).
3. Replace the cover.
Ç Remove the batteries if the label maker
will not be used for a long period of time.
Connecting the Optional Power Adapter
An optional 9 Volt, 1.5 A power adapter can also be used to power the label
maker. Connecting the AC adapter to the label maker disconnects the
batteries as a power source.
To connect the power adapter
1. Plug the power adapter into the power connector on the top, left side of
the label maker.
2. Plug the other end of the power adapter into a power outlet.
Ç Make sure the label maker power is turned off before you disconnect the
power adapter from the main power source. Otherwise, your most recent
memory settings will be lost.
Figure 2