Filter
Top Products
12
3. Enter or select the breaker length and
press .
Select the length that applies to the smallest size
breaker in the panel. You can then use breaker
multipliers to increase the size of any individual
breakers that are larger. The default breaker size
is 1.0” (25.4 mm).
4. Enter or select the number of breakers and
press .
5. Select the breaker multiplier for each breaker
and press .
Each breaker is separated by a solid black line on
the display.
6. Enter the text for each breaker in the label.
Use the up or down arrow key to move from
breaker to breaker.
To adjust the breaker multipliers after a label has
been created, see Using Breaker Multipliers on
page 12.
To create data for the breakers automatically, see
Creating a Series of Labels on page 16.
To print separator lines between the breakers, see
Printing Separator Lines Between Cells on
page 14.
Using Breaker Multipliers
Breaker multipliers allow you to adjust the size of
individual breakers within an Electrical Panel label.
To adjust the size of an individual breaker
1. Create an Electrical Panel label as described in
Creating Electrical Panel Labels.
2. Press .
3. Select Current label config. and press .
4. Select Breaker multipliers and press .
5. Use the up and down arrow keys to select the
breaker number to adjust and press =.
6. Select the multiplier for that breaker.
7. Press and then Done (OK) to
return to the label.
Printing Empty Breakers
By default, empty breakers at the end of an
Electrical Panel label are not printed. You can
choose whether or not to print empty breakers at
the end of a label.
To print empty breakers
1. Press .
2. Select Print empty breakers and
press .
3. Select On and press .
4. Select Done (OK) to return to the label.
Any empty breakers at the end of an Electrical
Panel label will now be printed.
Creating Block Labels
You can create two types of block labels: Terminal
Block and 110-Block labels.
Creating Terminal Block Labels
A Terminal Block label is
very similar to a Patch
Panel label; however, the
text is printed vertically
for each block.
To create a terminal
block label
1. Press .
2. Select Terminal block
and press .
3. Enter or select the number of blocks and
press .
4. Enter or select the block width and
press .
The default block width is 0.5” (17.5 mm).
Each block is separated by a solid black line on
the display.
5. Enter the text for each terminal.
Use the up or down arrow key to move from
terminal to terminal.
To create data for the terminal blocks automatically,
see Creating a Series of Labels on page 16.
To print separator lines between the ports, see
Printing Separator Lines Between Cells on
page 14.