Filter
Top Products
14
Printing Options
You can choose to print multiple copies of the same
label, collate the copies, pause to cut between labels,
advance the label tape, and adjust the print contrast.
Printing Multiple Copies
You can print up to 99 copies of the same label at one
time.
To print multiple copies
1. Press # COPIES (SHIFT + PRINT).
2. Press the
S arrow to increase the number of copies
to print. The default is 2 copies.
3. Press the
T arrow to decrease the number of
copies (maximum is 99).
4. Press OK or PRINT to begin printing.
You may notice a brief pause in printing
between each label for more complex formats.
When printing is finished, the number of copies to
print returns to 2.
Collating Multiple Copies
When printing multiple copies of a label file containing
more than one label, all the copies of a label are
printed before the next label starts printing. You can
choose to have the label file print collated, so each
complete copy of the file prints before the second copy
starts. The following example shows three copies of a
label file containing three labels printed normally and
collated.
Normal
A101 A101 A101 A102 A102 A102 A103 A103 A103
Collated
A101 A102 A103 A101 A102 A103 A101 A102 A103
To collate multiple copies
1. Press SETTINGS.
2. Select Collate multi. copies and press OK.
3. Select On.
4. Press OK and then select Done (ESC).
Pausing between Labels
By default the printer pauses after printing each label
so you can cut the label. You can turn this feature off to
have the labels print continuously.
To set the printer to print continuously
1. Press SETTINGS.
2. Select Pause to cut btw labels and press OK.
3. Select Off.
4. Press OK and then select Done (ESC).
Advancing the Label Tape
The default leader space for all labels is approximately
5/16” (10 mm). To add additional blank space to the
beginning or end of your label, you can feed the tape
in 5/16” (10 mm) increments.
To advance the tape
1. Press FEED (SHIFT + CUT).
2. Press OK to advance the tape.
Adjusting Print Contrast
Depending on the label material you choose, you may
need to lighten or darken the print on the label.
To adjust the print contrast
1. Press SETTINGS.
2. Select Print contrast and press OK.
3. Use the arrow keys to adjust the print contrast.
4. Press OK and then select Done (ESC).
5. Repeat as necessary until you are satisfied with the
print quality.