Filter
Top Products
Chapter 4: Web Configuration
27
Primary IP Address:
Type in the first IP address that you got from
your ISP for your LAN connection.
Subnet Mask:
Type in the subnet mask that you got from
your ISP for your LAN connection.
Configure the second IP Address and
Subnet Mask for LAN interface:
Check this box to make another set of IP
Address and Subnet Mask to connect to your
router if they are not included in the range
that DHCP server accepts.
Secondary IP Address:
Type in the second IP address that you got
from your ISP for your LAN connection.
Subnet Mask:
Type in the subnet mask that you got from
your ISP for your LAN connection.
Enable DHCP server on the LAN:
Check this item if DHCP service is needed
on the LAN. The router will assign IP
address, gateway address for each of your
PCs.
Start IP Address:
Type in the start point IP address.
End IP Address:
Type in the end point IP address.
Leased Time:
Type in the duration for the time. The default
is 1day.
On the Configure LAN side Settings web
page, the IP address and subnet mask will
be shown on it. You can modify them if
needed.
Type in all the necessary settings and
click Next for next page.
You can check it at this time. If you find
something is incorrect, click Back to change
the settings.
If everything is OK, click Finish to accept
these settings.
Now, the system will reboot to activate the
new settings that you have done in this
section.
Please wait for 2 minutes for restarting the
router.