Eaton Electrical 9140 Power Supply User Manual


 
INSTALLATION
EATON Powerware
®
9140 EBM User’s Guide S 164201623 Rev A FINAL DRAFT 2006 July 14
17
EBM Setup
The Powerware 9140 EBM comes with all hardware required for
installation in a standard EIA or JIS seismic rack-mount configuration
with square or round mounting holes. The rail assemblies adjust to
mount in 19-inch panel racks from 24 to 30 inches deep.
Checking the EBM Accessory Kit
Verify that the following items are included with the EBM:
S Mounting brackets and fasteners (if not already installed):
- (2) front mounting brackets
- (2) rear mounting brackets
- (12) M4 flat-head screws, plus (2) extra
S Rails and fasteners:
- (2) sliding rail assemblies (left and right)
- (4) adapter plates (for 7.1 mm round hole)
- (4) adapter plates (for 9.5 mm square hole)
- (16) M5 machine screws, plus (2) extra
- (2) M6 machine screws, plus (2) extra
- (2) M6 clip nuts for racks with round holes, plus (2) extra
- (2) M6 cage nuts for racks with square holes, plus (2) extra
- (8) M4 machine screws with (8) M4 locknuts, plus (2) extra of each
S EBM user’s guide
S Optional seismic mounting brackets and fasteners:
- (2) EBM seismic mounting brackets
- (4) wing bolts, plus (1) extra
- (4) M6 machine screws
NOTE Discard the EBM user’s guide if you are installing the EBM with a new UPS at the
same time. Use the UPS user’s guide instead to install both the UPS and the EBM.