Filter
Top Products
INSTALLATION
EATON Powerware
®
9140 EBM User’s Guide S 164201623 Rev A FINAL DRAFT 2006 July 14
24
Installing the EBM Batteries
To install the battery trays into the EBM cabinet:
1. Verify that the battery circuit breakers on the EBM rear panel are in
theOFF(O)position(seeFigure13onpage26).
2. Remove the EBM front cover (see Figure 10).
To remove the front cover, loosen the two front cover screws.
Grasp the fingergrips on both sides of the cover and pull the cover
forward firmly.
Figure 10. Removing the EBM Front Cover
3. Slide the battery trays into the cabinet (see Figure 11). Push each
tray in until the battery tray lock on the handle catches to lock the
tray in place.
Battery Tray
Lock
Figure 11. Installing the Battery Trays