Filter
Top Products
User Manual
Publication date: January, 2005
Revision A1
96
5. Maintenance
5-1. Resolving No Link Condition
The possible causes for a no link LED status are as follows:
The attached device is not powered on
The cable may not be the correct type or is faulty
The installed building premi se cable is faulty
The port may be faulty
5-2. Q&A
1. Computer A can connect to Computer B, but cannot connect to Computer C
through the 16 Gigabit Web Smart Switch.
The network device of Computer C may fail to work. Please check the link/act
status of Computer C on the LED indicator. Try another network device on this
connection.
The network configuration of Computer C may be something wrong. Please
verify the network configuration on Computer C.
2. The uplink connection function fails to work.
The connection ports on another must be connection ports. Please check if
connection ports are used on that 16 Gigabit Web Smart Switch.
Please check the uplink setup of the 16 Gigabit Web Smart Switch to verify the
uplink function is enabled.
3. The console interface cannot appear on the console port connection.
16 Gigabit Web Smart Switch has no console port, so you cannot use console
interface to connect with 16 Gigabit Web Smart Switch.
4. How to configure the 16 Gigabit Web Smart Switch.
User can use IE browser program in window series of computer to control the
web smart functions in 16 Gigabit Web Smart Switch. First, choose any port in 16
Gigabit Web Smart Switch. Then, use IE and type default IP address, 192.168.1.1,
to connect to 16 Gigabit with RJ45 network line. Finally, the login screen will appear
at once.