Filter
Top Products
User Manual
2-1-3-1. Configuring Management Agent of Gigabit Web Smart Switch through
Ethernet Port
There are two ways to configure and monitor the switch through the switch’s
Ethernet port. They are Web browser and SNMP manager. The user interface for
the last one is NMS dependent and does not cover here. We just introduce the first
type of management interface. Web-based UI for the switch is an interface in a
highly friendly way.
Publication date: January, 2005
Revision A1
15
16 Gigabit Web Smart Switch
Default IP Setting:
IP = 192.168.1.1
Subnet Mask = 255.255.255.0
Def ault Gateway = 192.168.1.254
Ethernet LAN
Def ault Gateway = 192.168.1.254
Fig. 2-6
A
ssign a reasonable IP address,
For example:
IP = 192.168.1.100
Subnet Mask = 255.255.255.0
• Managing Gigabit Web Smart Switch through Ethernet Port
Before you communicate with the switch, you have to finish first the
configuration of the IP address or to know the IP address of the switch. Then,
follow the procedures listed below.
Set up a physical path between the configured the switch and a PC
by a qualified UTP Cat. 5 cable with RJ-45 connector.
Note: If PC directly connects to the switch, you have to setup the
same subnet mask between them. But, subnet mask may be
different for the PC in the remote site. Please refer to Fig. 2-6 about
the Gigabit Web Smart Switch default IP address information.
Run web browser and follow the menu. Please refer to Chapter 4.