Filter
Top Products
Command Line Interface 120
SET HAYES CONNDELAY ConnectionEstablishment
Defines the maximum delay permitted between dialing a number and achieving a successful
connection. This delay includes the dialing and handshake time between external modems. If
this timer is exceeded, the call is abandoned.
Range: 15-65 seconds.
Default: 30.
SET HAYES RETRY retryLimit [retryDelay]
Defines the dial retry settings.
retryLimit: Maximum number of dialing attempts to be made when a busy or unresponsive
phone number is encountered. If a secondary number is defined, the dialer will alternate
between the primary and secondary numbers until a call is successfully completed or until the
retry limit is reached. Each time the primary or secondary number is dialed counts as a retry
attempt. For example, specifying 6 allows the primary and the secondary number to be dialed a
maximum of three times each. Range: 1-9. Default: 4.
retryDelay: Delay before redialing.
Range: 0-65 seconds. Default: 5.
SET HAYES RIDTR RidtrDelay
Defines the amount of time permitted between receipt of a ring signal detection and the
issuance of Data Terminal Ready (DTR) ON. If this delay is exceeded, the call is abandoned.
This value must not exceed the value for SET HAYES RING.
Range: 0-30000 milliseconds. Default: 1000.
SET HAYES HANGUP HangupDelay
Defines the amount of time after the line is disconnected before a new command can be issued.
This is used to give the modem enough time to prepare to accept other commands.
Range: 0-65 seconds.
Default: 2.
SET HAYES DSRLOSS DSRlossDelay
Defines how long Data Set Ready (DSR) must be lost to determine that there has been a valid
loss of carrier, not just a temporary fluctuation. A valid loss of DSR usually means the modem
will hang up.
Range: 0-10000 milliseconds.
Default: 1500.
SET HAYES RING RingDelay
Defines the permitted delay between rings. If this timer is exceeded, it is assumed that the caller
has hung up.
Range: 1-9000 milliseconds.
Default: 5000.