Filter
Top Products
40
Setting
Capture
This function enables you to capture an image being projected to
use it for the starting-up display or interval of presentations.
After capturing the projected image, go to the Logo function and
set it to “User”. Then the captured image can be displayed the
next time projector is turned on or when the NO SHOW button is
pressed. (p22)
To capture the image, select [Yes]. To cancel the Capture function,
select [No].
✔Note:
• Before capturing an image, select Standard in the Image Select Menu to capture a
proper image (p29, 34).
• A signal from a computer can be captured up to XGA(1024 x 768). A signal from
video equipment can be captured except for 720p, 1035i, and 1080i.
• When capturing the image that has been adjusted by the Keystone function, the
adjusted data is automatically reset and the projector captures an image without
keystone correction.
• When the Logo PIN code lock function is "On", the Logo and Capture menu cannot
be selected.
• When starting to capture a new image, the previously stored image is cleared even
if you cancel the capturing.
Select [Yes] to
capture the
projected image.
Select [Yes] to
stop capturing.
Capture
Logo
This function allows you to decide on the starting-up display from
among the following options.
User . . . . . . the image you captured
Default . . . . the factory-set logo
Off . . . . . . . countdown only
Ceiling
When this function is “On,” the picture is top/bottom and left/right
reversed. This function is used to project an image from the
ceiling-mounted projector.
Rear
When this function is “On,” the picture is left/right reversed. This
function is used to project an image to a rear projection screen.
Ceiling
Rear