Filter
Top Products
This projector has other functions settings: Blue back, Display, Ceiling, Rear, Split wipe, Power management, Remote control and
Lamp age.
See the next page menus figure and settings.
BLUE BLACK (On or Off)
When this function is in the “On” position, the projector will project a blue image without video noise on the screen when the
video source is unplugged or turned off.
DISPLAY (On or Off)
When this function is in the “On” position, on-screen displays always appears when adjustments are made. Although
these on-screen displays are very helpful, these may spoil the view if adjustments are made during presentations. To
avoid this, you can keep back certain displays by switching this function “Off”. The followings are the displays that
you can hide.
• Wait Display • Mode Display • Volume Display
• Mute Display • Zoom/Focus Display • D.Zoom Display
• Keystone Display • No show Display • Normal Display
CEILING (On or Off)
When this function is in the “On” position, the top/bottom and the left/right
picture reverse capability lets you project from a ceiling-mounted projector.
REAR (On or Off)
When this function is in the “On” position, the left/right picture reverse
capability
lets you project onto a rear projection screen
.
SPLIT WIPE (On or Off)
Turn SPLIT WIPE function On in the SETTING menu. The picture will change into the next one by sliding black
image side ways when the input source is changed.
Change the input source by MODE button. The picture is replaced by black image from side ways to the center, and
the next one appears from the center to side ways like drawing the black curtains.
POWER MANAGEMENT (On or OFF)
Power management will be turn the projector Lamp off when the input signal is interrupted (Picture is not displayed)
over 5 minutes. This aims at saving power and Lamp life. The Lamp is automatically turned on when the signal is
input.
To activate this function, turn the “Power management” in the SETTING menu “On”.