Filter
Top Products
1
IMPORTANT SAFETY INSTRUCTIONS
NOTE
Read the entire manual before installing or operating the system.
!
WARNING
The shipping bands may be under tension. Use appropriate eye, face, and hand protection to
safeguard against injury from band backlash.
!
WARNING
Verify that all incoming line voltage (power) and low-voltage (control) circuits are
de-energized and locked out before installing cables or making connections, whether in the
junction box or in the unit.
Equipment inspection and start-up should be performed only by trained personnel. Lethal
voltages are present during start-up procedures. Electrical safety precautions must be
followed throughout inspection and startup.
Only qualified service personnel should perform maintenance on the Liebert FPC system. All
voltage sources to the unit must be disconnected before inspecting or cleaning within the
cabinet.
Lethal voltages exist within the equipment during operation. Observe all warnings and
cautions in this manual. Failure to comply may result in serious injury or death. Obtain
qualified service for this equipment as instructed.
The monitoring system contains a lithium battery for memory backup. There is a danger of
explosion if battery is incorrectly replaced. Replace only with same or equivalent type.
Dispose of used batteries according to the manufacturer’s instructions.
NOTE
The unit should not be loosened from the shipping pallet until all handling by fork lift or pallet
jack is completed.
All power and control wiring should be installed by licensed electricians and must comply with
the NEC and applicable codes.