Filter
Top Products
IP258
37
Parameter Description Min. Max. Default
No. value value Ex-Factory
D750 Model Code Hart parameter - - -
D751 Serial Number - Control Unit - - -
Store as Final Assembly Number (FAN)
D752 Hardware Revision - - -
Factory-set
D753 Software Revision - - -
Factory-set, embedded in software
D760 Manufacturer’s Code - - -
Factory set not atlerable
D761 Unique ID - - -
Hart parameter
D762 Universal Command Revision - - -
Hart parameter
D763 Transmitter Specific Command Revision - - -
Hart parameter
D764 Preamble Bytes - - -
Hart parameter
D765 Flags Hart parameter - - -
D800 PV - - -
D801 Sludge Density - - -
D805 % Current Output - - -
D806 Current output Current is proportional to PV - - -
D810 Totaliser Value - - -
D820 Relay Status - - -
D821 Relay 1 Run-Time Resettable - Hours & Minutes - - -
D822 Relay 2 Run-Time Resettable - Hours & Minutes - - -
D830 Alarm report e.g. Sensor Fault, …. - - -
D835 Digital input status - - -
D841 Current input
Value of current input (mA) - - -
D844 Temperature
The temperature
o
C within the control unit - - -
D850 Attenuation @ 1MHz Attenuation - - -
D851 Attenuation @ 3.3MHz Attenuation - - -
D852 Attenuation unsmoothed - - -
D853 Signal level (Raw A/D bits)
Raw RF A/D output - - -
D854 Span Average @ 1MHz (dB)
Diagnostic parameter that averages the span calibrations - - -
D855 Span Average @ 3.3MHz
Diagnostic parameter that averages the span calibrations - - -
D858 Slope 1
The value of the attenuation in dB/% @ 1MHZ
determined by the control unit. - - -
D859 Slope 3
The value of the attenuation in dB/% @ 3.3MHZ
determined by the control unit. - - -
D860 Frequency of operation
Diagnostic of frequency(ies) being used (MHz) - - -
D861 Maximum density
The maximum density that can be measured.
This value is calculated from zero and span data. - - -