Supplement - 2
AK
90003752(1) [AK-Commands] 10/98
Code Function MLT local
V3.2
MLT/CU
V3.2
Other AM
V3.2
ELST Linearization steps
√ √
EMBA Begin of ranges
√ √ √
EMBE End of ranges
√ √ √
EMBU Switch levels for autorange
√ √
EMDR Manual pressure value
√ √
EPAR Parameters general
ESOL Setpoints with limits
√ √
ESYZ Time and date of the system
√ √
ET90 t90 times
√ √
ETOL Tolerances for stability controlled procedures
√ √
EVEZ Delay and synchronization time
√ √
EZEI Times for procedures
√ √
SALI Linearization check with span gases
√ √
SARA Autoranging OFF
√ √
SARE Autoranging ON
√ √
SATK Zero and span calibration
√ √
SCAL Start system calibration
√
SEGA Open spangas valve
√ √
SEMB Set range
√ √ √
SENO Switch to NO mode for CLD module
√
SFRZ Floating point format of real numbers
√ √ √
SGTS Switch to device test status
SHDA Hold mode OFF
√ √
SHDE Hold mode ON
√ √
SINT Start integration
√ √
SLCH Start linearization check
√ √
SLIN Start linearization
√ √
SLST Switch linearization step
√ √
SMAN Communication: Manual
√ √
SMGA Open sample gas valve
√ √
SNAB Zero calibration
√ √ √
SNGA Open zero gas valve
√ √
SNOX Switch to NOx mode for CLD module
√
SPAB Span calibration
√ √ √
SPAU Set to pause mode
√ √
SQEF Start cross interference measurement
√ √
SREM Communication: Remote
√ √
SRES µP-Reset
√ √ √
SROF Delay mode OFF
√ √
SRON Delay mode ON
√ √
SRUC Purge backwards
SSPL Open purge gas valve
√ √
ST90 Set t90 time
√ √
STBY Set to stand-by
√ √
Implemented additional Fisher-Rosemount specific commands (not official AK):
ALIK, AMBA, AMDR
EMBA, EMDR
SCAL, SFRZ, SHDA, SHDE, SNAB, SPAB
ASVC, ESVC, SSVC, (additional service commands)