Filter
Top Products
RTM-ATCA-7350 Installation and Use (6806800H30F)
Hardware Preparation and Installation Installing and Removing the RTM-ATCA-7350
30
5. Place the removed FC daughter card in an antistatic package.
6. Take the new FC daughter card out of the antistatic package.
7. Insert the FC daughter card in RTM-ATCA-7350 by facing the daughter card at an
angle of 45° to the RTM. Align the daughter card connector with the connector on
RTM-ATCA-7350, and the daughter card positioning holes with the plastic supports
on RTM-ATCA-7350. Exert even power downwards until the daughter card
connector is fully inserted into the connector on RTM-ATCA-7350 and the daughter
card is fastened by the plastic latches. See step 3 in the figure above.
8. Install
RTM-ATCA-7350 whose FC daughter card is replaced. For more information
refer, Installing RTM-ATCA-7350 on page 30.
After replacement, check if RTM-ATCA-7350 can be powered on and work normally. Use the
optical fibre to connect RTM-ATCA-7350 to the external storage system. Check if RTM-ATCA-
7350 can transmit data normally and monitor whether the FC status indicator is normal.
2.7 Installing and Removing the RTM-ATCA-7350
2.7.1 Installing RTM-ATCA-7350
Installation Procedure with Installed Front Blade
The following procedure describes the installation of RTM-ATCA-7350. It assumes that your
system is powered on. If your system is powered off, you can disregard the blue LED and thus
skip the respective step. In this case it is a purely mechanical installation. The same applies to
an installation without an installed front blade. In this case disregard the LEDs and skip the
respective step.
1. Wear the ESD-preventive wrist strap. For more information refer, Wearing the ESD-
Preventive Wrist Strap on page 21.
2. Unlatch the lower handle of the front blade outward by squeezing the lever and the
latch together and turning the handle outward only enough to unlatch the handle
from the face plate, that means until you feel a resistance. Do not rotate the handle
fully outward.
Product Damage
You can install RTM-ATCA-7350 into a system if the front blade is already installed or
if it is not installed. In case the front blade is already installed, its payload has to be
powered down first.