Support User Manuals

Enterasys Networks 2G4082-25 Network Router User Manual

Open as PDF

of 58

Pin Out Descriptions Completing the Installation of a New System

Matrix DFE-Platinum Series Installation Guide 3-15

Completing the Installation of a New System

The2G4082‐25becomesthemanagementmoduleontheMatrixchassispowerup.Acompletelist

ofthefactorydefaultvaluesareprovidedintheEnterasysMatrix DFE‐Diamond/PlatinumSeries

ConfigurationGuide.

Afterinstallingthe2G4082‐25intothechassisandmakingtheconnectionstothenetwork,

proceedto“First‐

TimeLog‐InUsingaConsolePortConnection”onpage 3‐15,toaccessthe

modulemanagementstartupscreenfromyourPC,terminal,ormodemconnection.

First-Time Log-In Using a Console Port Connection

StarttheCommandLineInterface(CLI)fromthemodule’slocalconsoleportasfollows:

1. Connectaterminaltothelocalconsoleportasdescribedin“ConnectingtoCOMPortfor

LocalManagement”onpage 3 ‐10.Thestartupscreen,Figure 3‐11,displays.

2. Attheloginprompt,enteroneofthefollowing

defaultusernames:

– roforRead‐Onlyaccess,

– rwforRead‐Writeaccess,or

– adminforSuperUseraccess.(ThisaccesslevelallowsRead‐Writeaccesstoallmodifiable

parameters,includinguseraccounts.)

3. PressEnter.

4. ThePasswordpromptdisplays.LeavethisstringblankandpressEnter.Themodule

informationand

MatrixpromptdisplaysasshowninFigure 3‐11.

TheDFE‐Platinummoduleisnowreadytobeconfigured.ForinformationaboutsettingtheIP

addressandconfiguringTelnetsettingsforremoteaccesstoDFEmanagement,refertothe

EnterasysMatrixDFE‐Diamond/PlatinumSeriesConfigurationGuide.TheCLIcommandsenableyou



toinitiallysetupandperformmoreinvolvedmanagementconfigurations.

TheEnterasysMatrixDFE‐Diamond/PlatinumSeriesConfigurationGuideisavailableonlineat:

http://www.enterasys .com/support/manuals

Ifyourequireassistance,contactEnterasysNetworksusingoneofthemethodsdescribedin

“GettingHelp”onpage xiii.

Note: The DFE-Platinum 2G4082-25 module can be installed in the single-slot of the Matrix N1

chassis, or in any slot of the Matrix E7, Matrix N7, Matrix N5, or Matrix N3, but does not have FTM

connectivity.

When installed in the Matrix E7, Matrix N7, Matrix N5, or Matrix N3, the 2G4082-25 will boot as a

standalone device with no connectivity to other modules in the chassis.

Note: This procedure applies only to initial log-in, and to logging in to a device not yet configured

with administratively-supplied user and password settings.

By default, the Matrix DFE Series device is configured with three user login accounts: ro for Read-

Only access; rw for Read-Write access; and admin for super-user access to all modifiable

parameters. The default password is set to blank (carriage return). For information on changing

these default passwords, refer to the

Enterasys Matrix DFE-Diamond/Platinum Series

Configuration Guide

.

previous next