Support User Manuals

Enterasys Networks 2G4082-25 Network Router User Manual

Open as PDF

of 58

Overview of DFE-Platinum Module Shutdown Procedure

4-6 Troubleshooting

Recommended Shutdown Procedure

BeforepullingaDFE‐Platinummoduleoutofachassis,

pressortaponits

OFFLINE/RESETswitchforlessthan1 second.

ItsCPULEDchangesfromsolidgreentoblinkingbetweengreenandamber,indicatingthatthe

moduleisshuttingdown.Attheendoftheshutdownroutine,theCPULEDchangestoa67%/

33%sequenceofamber/off,respectively,indicatingthemoduleisinahalt

state.Inthistimeitis

safetorestartorremovethemodule fromthechassis.

Whenacontrolledshutdownisinitiatedfromthe

OFFLINE/RESETswitch,youhave60seconds

fromthetimetheCPUstartsalternatelyflashingamber/offuntilthedeviceautomaticallyrestarts.

Last Resort Shutdown Procedure

ToresetaDFE‐Platinummodulewithoutitperforminganorderlyshutdownroutine,

pressandholdthe

OFFLINE/RESETswitchforapproximately6seconds.

PullinganyDFE‐Platinummoduleoutofthechassisbeforeithasbeenshutdownisnot

recommended.Theonlysafetimetopullamoduleoutofthechassisisafterthecompletionofa

shutdownandthemanagementLEDisalternatelyflashingamber/off.

Caution: Do not remove a DFE module from an operating chassis system before reading the

following information and instructions.

Precaución: Antes de retirar los módulos DFE del chasis en funcionamiento, lea las siguientes

instrucciones y la información suministrada.

Note: The only safe time to pull a DFE-Platinum module out of the chassis is when the CPU LED is

alternately flashing amber/off. Otherwise, system operation will be interrupted.

Caution: This method of shutting down a DFE module is not recommended except as a last resort,

because all processes currently running on the module will be interrupted resulting in loss of

frames.

Precaución: No se recomienda utilizar este método para apagar los módulos DFE. Recurra a él

sólo como último recurso, puesto que interrumpe todos los procesos del módulo en

funcionamiento, lo que podría resultar pérdidas de frames.

previous next