Filter
Top Products
Unpacking the Module
3-2 Installation
3.1 UNPACKING THE MODULE
Unpack the module as follows:
1. Open the box and remove the packing material protecting the module.
2. Verify the contents of the carton as listed in Table 3-1.
3. Remove the tape seal on the non-conductive bag to remove the module.
4. Perform a visual inspection of the module for any signs of physical damage. Contact Enterasys
Networks if there are any signs of damage. Refer to “Getting Help” in About This Guide for
details.
3.2 INSTALLING OPTIONAL FLASH UPGRADE
If the module is to be installed with an optional FLASH upgrade, refer to Appendix B for
installation instructions.
Table 3-1 Contents of Module Carton
Item Quantity
The 6H308-24 or 6H308-48 Module 1
Antistatic Wrist Strap 1
Manual Accessory Kit 1
NOTE: Install any optional equipment before proceeding to Section 3.3.