Support User Manuals

Enterasys Networks 7KR4297-04 Switch User Manual

Open as PDF

of 64

Overview of DFE-Diamond Module Shutdown Procedure

4-6 Troubleshooting

Recommended Shutdown Procedure Using OFFLINE/RESET Switch

BeforepullingaDFE‐Diamondmoduleoutofachassis,

pressortaponitsOFFLINE/RESETswitchforlessthan1 second.

ItsCPULEDchangesfromsolidgreentoblinkingbetweengreenandamber,indicatingthatthe

DFE‐Diamondmoduleisshuttingdown.Attheendoftheshutdownroutine,the

CPULED

changestoa67%/33%sequenceofamber/off,respectively,indicatingthatthemoduleisinahalt

state.AtthistimeitissafetorestartorremovetheDFE‐Diamondmodulefromthechassis.

WhenacontrolledshutdownisinitiatedfromtheOFFLINE/RESETswitch,youhave60seconds

from

thetimetheCPUstartsflashingamber/offuntilthetimethedeviceisautomatically

restarted.

Figure 4-2 OFFLINE/RESET Switch

1 OFFLINE/RESET switch

Caution: Do not pull any DFE-Diamond module out of an operating chassis before it has completed

its shutdown routine.

Precaución: No retire los módulos DFE-Platinum del chasis en funcionamiento hasta que no se

haya terminado con la rutina de apagado.

Note: The only safe time to pull a DFE-Diamond module out of the chassis is when the CPU LED is

blinking amber. Otherwise, system operation will be interrupted.

previous next