Support User Manuals

Enterasys Networks A2H124-24FX Switch User Manual

Open as PDF

of 82

Considerations Prior to Installation

3-2 Hardware Installation

Considerations Prior to Installation

Wheninstallingtheswitch,notethefollowing:

•Beforestartingtheinstallationprocedure,notifythenetworkadministratorofthe

installation.

•Followtheinstallationproceduresintheorderaspresentedinthisguide.

•DonotconnecttheswitchtothenetworkuntilyouhaveestablishedthecorrectIP

address.

Required Tools

APhillipsscrewdriverisrequiredtoinstalltheswitchintoarack.

Unpacking the Switch

Unpacktheswitchas follows:

1. Opentheboxandremovethepackingmaterialprotectingtheswitch.

2. Verifythatthecontentsofthecartoncontainsthe itemslistedinTable 3‐1.

3. Removethetapesealonthenon‐conductivebagtoremovetheswitch.

4. Performavisualinspectionoftheswitchforany

signsofphysicaldamage.Contact

Enterasys Networksifthereareanysignsofdamage.Referto“GettingHelp”on

page 1‐6fordetails.

Table 3-1 Contents of Switch Carton

Item Quantity

A2H124-24FX Switch 1

Mounting kit (two mounting brackets and eight M3x6-mm screws for rack mounting) 1

Rubber feet with adhesive backing for installation on a flat surface 4

AC power cord (The type of power cord is country dependent.) 1

This installation guide 1

Customer Release Notes 1

URL notice card 1

previous next